Build stone pillars for entrance entries or corners of the fence

The stone pillars are beautiful additions to their landscape and are a permanent way of making a statement. You can build your own decorative column of cement blocks and stone sheet.

Build stone pillars: How to build a decorative stone column for fences or entrance paths

A stone column or pillar is a way of making a dramatic statement at the end of your input path, for a mailbox publishing or corner of a wrought iron fence.

The concrete blocks, often called cement blocks, make a good basis for a field stone or a cultivated stone cover. Here is how to build yours.

Stone columns

A stone column at the end of your entrance path or in a corner of the fence is not only great, but also offers a place to put your home number, light and maybe even a mailbox.

Even if you are not a Stonemason, you can probably build your own use of a concrete base, cement blocks for a column and a stone sheet to cover the outside.

The project takes three to four days, depending on how big it decides to build the column and the type of sheet that you want to put on it. Let’s look at how to build a decorative stone column.

Base

Plan the piece before digging it and decide if you want the pad at ground level where it looks or 4 inches below the ground level so that the grass grows over the top.

A 6-inch deep crushed stone base should be placed a wider foot in all directions as the concrete pad for the column with four inches of sand on top of that.

A depth concrete base of 3 1/2 inches having 6 inches wider than the column in all directions is placed in the center of the stone and the sand base.

Anuja the crushed stone, add the sand and the tamp. Build the form of concrete of the wood of 2 by 4 and level at the top of the sand.

Mix sufficient concrete to fill out the form and pour it, using a shovel for “Poke” on the concrete and resolve it.

Use a scrap 2-por-4 to level the concrete with the top of the form. Fill the surface so that it is soft and use a border to break the concrete of the forms as it is established.

Mix the mortar and place it at the concrete base where the blocks are going. He wants a layer of approximately 1 inch thickness and there are no empty in the mortar where the block will be established.

Establish a block in the mortar and resolve it in place approximately 3/8 inch on the slab and level it. As it puts additional blocks, place a 3/8 inches mortar pearl along the vertical joints between the blocks.

Look in the Resources section below for information on the lever mortar for cement blocks. Place the additional courses until it reaches the desired height of the column.

Be sure to compensate the joints between a layer block to the layer and to clean the excess mortar of the block to keep the sides gentle.

Add the stone sheet cover

Once again, you are mixing mortar and take it, but this time it is all vertical. Applying it to the flat surface of the blocks with a notched trowel is much easier than hitting a pearl on the narrow edge of a block.

Some stone veneers are installed from the top, others from bottom to top. Check to make sure you are doing it in the right way. Press the flat edges of the stone sheet towards the mortar.

One way to work in a column is to install two corner pieces to the right and two on the left. Fill the space between side pieces.

Then, move the next side, install two more corner pieces, complete the space between. Continue working around the spine until you reach the top.

For a more rustic appearance, complete the joints between stones with mortar as their work and smooth with a joint trowel. You can also buy color mortars to use as a grout in the joints.

Options

Use a piece of block the thickness of the stone sheet with the number of your home engraved on it as a steering marker.

Run a metal or PVC conduit from the bottom of the pot up through the center to install a light at the top. Be sure to execute your wiring before pouring the slab.

If you have the stone and patience, build the natural stone column. It is more work, but the final result is more natural aspect and you can try the pyramids or conical columns if you wish.

A stone column is a good place for a mailbox if you are allowed where you live.

Leave a Reply

Your email address will not be published. Required fields are marked *